Kitchener/Waterloo area, c u next trackday riders thread! | Page 35 | GTAMotorcycle.com

Kitchener/Waterloo area, c u next trackday riders thread!

Sounds like a great day. Hopefully tomorrow will be that empty! I really hope they don't do that stupid 4 corner speed track tomorrow...

Steve, I'll bring jumper cables.
 
Tim you've been warned. Karma is a *itch lol

Good luck tomorrow guys. I can't wait for it to warm up more and spend some good time at the track.

Tim just for that comment my offers dropped "Punn intended" to $2400
 
09SV650S said:
Tim you've been warned. Karma is a *itch lol
Click to expand...

she kicked my as* today for sure...
Find out if surgery is needed wednesday.. think it will considering the location of the break.

stupid rider (aka me) error.. Didn't release front brake on run off. Front wheel locked. Kaboom.

end result below.

clavicle2.jpg


clavicle1.jpg
 
Last edited:
Call me if you need anything. 519-746-6084
 
That sucks Tim, but you will be getting an award for this one :). Hope it heals fast without too much pain. GWS
 
Crappy to see that happen .. GWS buddy. Hope u heal up in time for the dragon ?
 
That sucks! GWS!
 
thanks for the gws wishes...
taking the day off work tomorrow and go to the hospital tomorrow to see if I can get in to see a specialist before Wednesday...

Suzi doesn't appear too badly damaged... bit of fiberglassing and bondo work to do, and think she's going to need a new shift lever. Jer swung by and unloaded her for me. Says it doesn't want to go into neutral and even with the clutch pulled there's a ton of resistance to motion. Really hope I didn't screw up the shift forks in the tranny - if I did, I'll probably end up having to part her out, 'cause it would cost a ton to fix..

Sigh...

and I repeat, *SIGH*
 
Bigevildoer said:
Suzi doesn't appear too badly damaged... bit of fiberglassing and bondo work to do, and think she's going to need a new shift lever. Jer swung by and unloaded her for me. Says it doesn't want to go into neutral and even with the clutch pulled there's a ton of resistance to motion. Really hope I didn't screw up the shift forks in the tranny - if I did, I'll probably end up having to part her out, 'cause it would cost a ton to fix..

Sigh...

and I repeat, *SIGH*
Click to expand...

Don't worry, your tranny is fine. It is probably binding in the pivot if the lever is bent badly enough or if the peg bracket got tweaked. I have what you need, pretty sure they fit 2nd gen 650 to 1000.

Speedy recovery buddy, and we'll get you back out there this season. Don't get scared in the brain, it was a little mistake (everybody makes them) you just got unlucky. Roll the dice again and go for it :)
 
I just took a quick look through a few of the videos I took and they turned out great, with lots of passing action. Randy, the camera stopped recording at 24 minutes (battery probably died) in the last session, right before our 4 or 5 lap battle :( Too bad... Got lots of other good action though. I'll go through it in more detail and make some YouTube versions on the rainy days this week. Did you wife get some good pictures?
 
Bigevildoer said:
thanks for the gws wishes...
taking the day off work tomorrow and go to the hospital tomorrow to see if I can get in to see a specialist before Wednesday...

Suzi doesn't appear too badly damaged... bit of fiberglassing and bondo work to do, and think she's going to need a new shift lever. Jer swung by and unloaded her for me. Says it doesn't want to go into neutral and even with the clutch pulled there's a ton of resistance to motion. Really hope I didn't screw up the shift forks in the tranny - if I did, I'll probably end up having to part her out, 'cause it would cost a ton to fix..

Sigh...

and I repeat, *SIGH*
Click to expand...
It should be OK it was going into neutral at the track when we were loading it, I think something outside is binding. It will be good as new in no time SV parts are cheap. We can always raid Jer's bike for parts :).

I think the nickname will have to be decided over beers sometime soon, this kind of thing needs group input.

Don't get to freaked out over this you made a simple mistake, take it slow and things will be good.
 
Scuba Steve said:
I think the nickname will have to be decided over beers sometime soon, this kind of thing needs group input.
Click to expand...
I think it should be decided over "tylenol 3's" I just talked to Tim.He's going to need a supply of some in the morning! GWS bud.
 
your support is amazing guys...
unfortunately, shannonville is out. the simple action of putting on a shirt is agonizing enough to make me woozy... bone didnt settle in right place earlier and my vision went dim putting it back in.

kind of hoping for surgery, as it will heal that much faster.

thanks for the parts and help offers... depending on healing, plan on starting repairs in a month... will definitely get back on track soon... maybe a bit less push to start, but will be back.
 
Back away from the keyboard bud.Flat on your back is boring but better for all those soft tissues that are getting more bruised and damaged while you are moving around with a broken bone.
Nuf said.......doctor is next.
You will heal a lot faster being a couch potatoe now.
Forum Sponsor
 
You must log in or register to reply here.

Back
Top Bottom