Bought a 2012 Ninja 250r

Forum Sponsor
mksliao said:
Just remove the light piece and run your wire up to where the factory wire clip is, and then slice up the wire a bit and join the wires from the led to the connector on the bike. I had to make a hole on teh oval factory light holder to put thewire through.
Click to expand...
mksliao said:
btw did u buy the light yet, cos i bought 2 i was gonna use a pair on my car, tooo much work to do it.
Click to expand...
Thanks for the reply mksliao. Do you have any pics of your FE setup? I have not started this project yet. I want to take my time with it if I end up going the DIY route, I am off next week so I may begin it then.
 
i hope the pic is clear i will get some closer shots maybe tomorrow.But for $15 bucks can't go wrong.
 
mksliao said:
View attachment 29605View attachment 29606
Click to expand...
mksliao said:
i hope the pic is clear i will get some closer shots maybe tomorrow.But for $15 bucks can't go wrong.
Click to expand...
Thanks! I've already hacked off my fender LOL. Just have to sand it down and cleanup some of the cuts and put it back together. Then I just need to pick-up a couple of "L" brackets tomorrow so I can attach the plate holder back on. It'll do for this year. I still need to grab some of those LEDs, I have a Royal Distributing a 2 minute ride from my work so I can grab those too.
 
If it's a 2012 u don't even need any brackets. The plate bracket that comes with bike bolts right on.
 
mksliao said:
If it's a 2012 u don't even need any brackets. The plate bracket that comes with bike bolts right on.
Click to expand...
Well that is true, I was a little more aggressive with my hacking. That piece is gone. Your way would have been much easier. I want my plate tucked in a bit under the tail light which means a little more work. Hopefully it will
look as clean as yours. I will post pics when I am done.

Pics of the hackjob..... hopefully it will be installed at lunch. Not attached yet.

plate1m.jpg


plate2z.jpg
 
Last edited:
Well I have my plate thing mounted back to the taillight.... one word. G H E T T O Fender Eliminator. Not as clean as I wanted but it should work. Just have to pop it back onto the bike this afternoon when I am done work. Will post pics when I am done. I'd suggest looking at how mksliao did it over the mess I made.
 
Legend said:
Well with my M1 and M1 exit completed I made the leap of faith and bought a 2012 Candy Lime Green Ninja 250r. I can't go to the MTO to upgrade to my M2 for another 30 days

i have to wait 60 days :(
Click to expand...
 
I see you've been turning left much more than right ;)

Bike looks awesome... :thumbup: I've got to order some new Ninja stickers, can't believe the last guy took em off mine.
 
You must log in or register to reply here.
Back
Top Bottom