Waiting for a new 2022 bike to come in
Spending like a drunken sailor ordering new race parts the last couple of weeks
Spending like a drunken sailor ordering new race parts the last couple of weeks
You could bend that back easily. See the soap trick in the tech tips.Spoke too soon. Right side peg is cross threaded, and the powdercoat had to be wire wheeled off where it goes through the rear brake.
The rest of it is fine.
Had to use some non-bent stock parts with the china copy brackets.
Better than this bent mess.
Sent from my SM-G903W using Tapatalk
Good time to remove the exhaust valve while you’ve got the tail apart if you haven’t already. Thing weighs a bunch.Cleaned up and put the tail section together. This girl has a big ass.
Sent from my SM-G903W using Tapatalk
Servo motor is long gone. I've got the dash "chec" light to prove it.Good time to remove the exhaust valve while you’ve got the tail apart if you haven’t already. Thing weighs a bunch.
I'll have to look for the soap trick.You could bend that back easily. See the soap trick in the tech tips.
Pull out pin #30 from the harness under your seat.Servo motor is long gone. I've got the dash "chec" light to prove it.
Any way to flash that or put in a resistor? I have to do some research. You said you had one of these.
Sent from my SM-G903W using Tapatalk
There’s a 6ish part YouTube series from a bmw guy that shows quite clearly and simply how to use it. Couple episodes have to do with the bmw integration part but most of the series should be really useful for you.Winter project for me is to master Garmin Basecamp. I used Mapsource years ago, and when Basecamp came along i was baffled.
Not going anywhere, but it's the thought that counts.
A little like listening to Mr Rogers, but this guy is easy to follow.There’s a 6ish part YouTube series from a bmw guy that shows quite clearly and simply how to use it. Couple episodes have to do with the bmw integration part but most of the series should be really useful for you.
First episode is called “Introduction to the BMW Navigator 6”. Couple episodes in is where it’ll be useful.
Rub bar soap on the part. Heat it with a propane torch. When the soap goes dark brown or black it's warm enough to bend without breaking it.I'll have to look for the soap trick.
Tried map gas, a bench vise, and a rubber mallot. No dice.
Sent from my SM-G903W using Tapatalk
Do you have a link to the BMW guy? I'm no getting very far.There’s a 6ish part YouTube series from a bmw guy that shows quite clearly and simply how to use it. Couple episodes have to do with the bmw integration part but most of the series should be really useful for you.
First episode is called “Introduction to the BMW Navigator 6”. Couple episodes in is where it’ll be useful.
The title to the YouTube vid is what I posted there.Do you have a link to the BMW guy? I'm no getting very far.
Do you have a link to the BMW guy? I'm no getting very far.
If all else fails, read the God damn instructions.Do you have a link to the BMW guy? I'm no getting very far.