Some sanity checks before going for a new panel....Looking for recommendations on electricians in the Barrie / Wasaga Beach / Collingwood area.
Trying to put in 100A service at the cottage. The 60A service was really struggling when a window air conditioner was on. Damn lights were flickering.
Parents never got around to putting in a real air conditioner so it's a stupid tiny little window unit that does a garbage job of cooling off the cottage.
I'll ask my guy, but doubt he'll go up all that way for a simple panel install.
All good ideas. MP, if you want to borrow a good multimeter let me know and you can grab one on the way by. Did you check the panel when you had the thermal camera? It will quickly show dodgy connections.Some sanity checks before going for a new panel....
Lights dimming are due to a voltage drop when the current increases (either starting surge or just running). Some may be natural for long wire runs (loop resistance). The voltage drop is due to resistance in the circuit and just swapping the panel may not solve anything if the problem is downstream of the panel. It the voltage drop is due to a bad connection somewhere it will also be a hot spot and potential fire hazard. At the same time cleaning up a fuse holder or two may solve the problem for free.... or the bad connection at an outlet.
- Are the lights that are flickering on the same circuit or are they on a different one?
- If on the same check the screw fuse holder (assuming fuses as it is 60A) for corrosion, if it is clean it up. Could also be a bad connection in the circuit somewhere else.
- You can also check voltage at the panel and at lights, better with an older analogue volt meter when the AC cycles on and off (as you will see the dial swing). Look for where or if it drops.
- Mains (fuse) may even need to be cleaned up or the main shutoff, see where/if the voltage drops.
- Is the cottage K&T or aluminum? New can of worms.
If memory serves me correctly the CSA defines 127+ as extreme service over voltage or something like that...All good ideas. MP, if you want to borrow a good multimeter let me know and you can grab one on the way by. Did you check the panel when you had the thermal camera? It will quickly show dodgy connections.
The voltage at our current house is surprisingly high. ~127 on each leg and ~255 across. If I do everything I can to load house, I cant get down to 240. LED lights dimmed to minimum will go out when hair dryer is turned on on same circuit which isnt surprising. If they are turned up, no noticeable change.
That's lovely. I have 126.4 and 126.2 now with most of the neighbours having A/C on. Our water pressure is up to 90 psi too. I don't know why they are shooting for the high end of all the ranges. Next time I have plumbing apart I have a regulator to go in and drop it to 60 psi (adjustable, I'll start there).If memory serves me correctly the CSA defines 127+ as extreme service over voltage or something like that...
I am sitting at 124V/248V myself at the panel. Something like 110 to 125 is "normal".
I use something like this for chipmunks. Also will catch squirrels. Lately it's been about one a day. General PDP TemplateJust saved a chipmunk from my dogs paddling pool. He was doing laps while my dog was patting him and barking. Poor little bugger collapsed exhausted but after 15 mins he toddled off to live another day. Just bought a critter saver off Amazon. My wife doesn’t care for the chipmunks as one managed to get into the house once and was sitting on a shelf one day when she went to the bathroom. For the sake of my eardrums I went to get some traps and we got rid of a few from the house. I actually like them, they are a lot cuter than rats and seem pretty smart (apart from the pool). They also hoover up the stuff that the grackles throw all over the garden from the bird feeders.
On the voltage you may be near the transformer. In many cases they are running hot because they are undersized for the modern load for the secondary cables and they are trying to be high enough end of the line...That's lovely. I have 126.4 and 126.2 now with most of the neighbours having A/C on. Our water pressure is up to 90 psi too. I don't know why they are shooting for the high end of all the ranges. Next time I have plumbing apart I have a regulator to go in and drop it to 60 psi (adjustable, I'll start there).
Subdivision is ~15 years old so I hope appropriately sized cable. I am closest house to transformer.On the voltage you may be near the transformer. In many cases they are running hot because they are undersized for the modern load for the secondary cables and they are trying to be high enough end of the line...
Water pressure IDK.
So furthest house is probably at the lower limit.Subdivision is ~15 years old so I hope appropriately sized cable. I am closest house to transformer.
Or they just turn everything to "11" so they don't have to think about it....So furthest house is probably at the lower limit.
Sent from my Pixel 5 using Tapatalk
Leave it if it is green it is good enoughOK GTAM…how do I fix my lawn from this weed back to grass….please don’t say tear it all up.
View attachment 56097
Killex. Cant buy it in Ontario but there are work arounds.OK GTAM…how do I fix my lawn from this weed back to grass….please don’t say tear it all up.
OK GTAM…how do I fix my lawn from this weed back to grass….please don’t say tear it all up.
View attachment 56097
I think my daughter imported something similar from Manitoba. I need some as well.Killex. Cant buy it in Ontario but there are work arounds.
1L OF KILLEX CONCENTRATE (Original product)
The best weed killer product in the market! Killex is the king when it comes to lawn weed control™ Now available for shipping in Ontario and Quebec! Killex is the best weed killer product in the market!. It is a very well establish brand with millions of happy users. Killex is best known for to...www.lawnsupplements.ca
I stocked up on a few litres before it was banned here. This stuff is amazing. It will kill any non-grass thing and leave the grass alone. A litre should last you a couple of years years a small spot sprayer (empty Windex bottle). You only need about a tbl spoon of the stuff and the rest water in a spray bottle to get rid of it. Gone in a day or less
NOTE: It seems to kill grass seed but not established grass so dont reseed until you are sure everything you dont want is gone for good.
The broad-leaf looks to be mostly creeping charlie. Broad-leaf specific herbicides that will kill it and not the grass are the solution if you want to get rid of it without hitting the reset button. The eco stuff that is legal/available in Ontario mostly uses iron which kills the foliage not the roots, this includes the stuff you can buy to use retail and Fiesta used by lawn care companies these days. It comes back but if you bomb immediately a few times as it does the roots will run out of energy and eventually die, just not a one and done process.OK GTAM…how do I fix my lawn from this weed back to grass….please don’t say tear it all up.
View attachment 56097
That's me today, except I'm fishing for bunnies.Had two resident chippies behind the pool waterfall. Down to one now as one went for a dip and never made it back out....