With no garage but a driveway (so wet location) and a house. In materials a "Level 2" outdoor charging set-up is ~$500 in materials before taxes but there could be complications.
$270 to 300 for the 40 amp GFCI breaker (depends on panel).
$80 for the NEMA 14-50R covered "RV" outlet, mounted to the house.
$80 for the single device ESA permit.
Rest in wire, clamps, screws....depends on the distance so it could bump over $500 by a little due to wire costs.
+Taxes
GFCI breaker is the biggest cost item, if you can possibly get away without GFCI that drops to under $30 for most panels (garage but it depends).
Now if you have to pay an electrician (no electrical DIY skills) well that will cost you. The biggest complication is if your panel and/or service is at or over its limit, you may need to do a full service upgrade to 200A so add a couple of grand for an electrician or more at that point (DIY likely less than a grand depending on the type of service). House has knob and tube well that may require even more when the can of worms is opened..... SO, low point under $500, high point for a house could be many thousands due to because of this, you need to do this, that and these.
Of course some people may go DIY without permit and forgo the GFCI for outdoor and squeeze it in an overloaded panel by installing some half height breakers on other circuits.... and will get it done in the $200 to $300 range, but we are talking legal here..... are we not????
Everyone I know that has an electric car got a plug-in "Level 2" charger with the car that will plug into the NEMA 14-50R, if someone did not, well that was their choice....
For people with an existing condo or apartment it may not even be possible but for sure it will be big $$$$s. Condo townhome may have specific rules and will likely require a licensed contractor to do the work if it is possible.