They are adding or rebuilding from pad up? I cant see how an addition would be cost effective as you would have to support the office on posts (which means you need footings which means you are in to the slab . . . ). If they start from the slab, they might get somebody to sign off as it is then a distributed load using graded lumber.
Yes I know a few people with shed offices but none so far with "legal" shed offices....
My neighbour plans on building a second story on their detached garage for a home office but they are getting permits etc. I am interested in how that unfolds (typical single car 1940s detached built with 2X4s on a pad).
Yes I know a few people with shed offices but none so far with "legal" shed offices....
My neighbour plans on building a second story on their detached garage for a home office but they are getting permits etc. I am interested in how that unfolds (typical single car 1940s detached built with 2X4s on a pad).
Even if it is (which I agree is doubtful as they were stingy with studs), the studs would be rough cut 2x4, not graded lumber so it is hard to get anyone to sign off. Even if they were brand new rough cut, it is hard to get a sign off even though they are larger and quite likely stronger, they have no stamp so therefore they may as well be cardboard.
They are a pain in the ***
I use to have to set them up for users, we went through thousands of $ trying to find good ones that apparently do not exist ymmv.
It was $250 and I put my own tabletop on to it so I could get the size I wanted. Currently houses two monitors, office essentials, and my breakfast. Lifts and lowers as smooth as when new.
In some municipalities you are required to pull permits for just about everything. My kid had to replace some blocks at the corner of his foundation (dinged by snow plow) - Permit required. When they came for inspection, they noticed we were changing from paneling to drywall in the basement. Because he was removing the paneling (ve drywalling over it) they asked he pull a permit. Reason was any change to walls made it necessary to bring them up to code for insulation and fire.
In some municipalities you are required to pull permits for just about everything. My kid had to replace some blocks at the corner of his foundation (dinged by snow plow) - Permit required. When they came for inspection, they noticed we were changing from paneling to drywall in the basement. Because he was removing the paneling (ve drywalling over it) they asked he pull a permit. Reason was any change to walls made it necessary to bring them up to code for insulation and fire.
If I was going to live up by him, I would probably buy in one of the many unincorporated municipalities where you are on your own to make decisions you think are right with no oversight.
Even if it is (which I agree is doubtful as they were stingy with studs), the studs would be rough cut 2x4, not graded lumber so it is hard to get anyone to sign off. Even if they were brand new rough cut, it is hard to get a sign off even though they are larger and quite likely stronger, they have no stamp so therefore they may as well be cardboard.
I "helped" him do some garage electrical.... The garage studs are not spruce, pine, whatever. They all are also true 2X4 rough cut. My best guess was redwood based on the smell and colour of the fresh electrical holes and sawdust.
They built an addition (second floor on a previous addition) on the house last year and had to get a variance as the garage was already too close to the existing house. The inspector also made them dig down to their footings for inspection on our property before they could proceed (as that side was a crawl space). As I said, I am interested to see if they actually let them do it and what doing it means.
When they came for inspection, they noticed we were changing from paneling to drywall in the basement. Because he was removing the paneling (ve drywalling over it) they asked he pull a permit. Reason was any change to walls made it necessary to bring them up to code for insulation and fire.
Wow that's nuts. Sure hope that's not needed here....just replaced all of my paneling with drywall (fire rated 5/8") in the garage and insulated the crap out of it. Can definitely feel a difference in our and daughter's bedrooms on the floor now that it's getting cooler. Garage stays nice and warm so far as well...we will see once the real cold comes in.
If I was going to live up by him, I would probably buy in one of the many unincorporated municipalities where you are on your own to make decisions you think are right with no oversight.
I think it's more of a money thing. The inspectors are great, they are helpful particularly with older buildings. We're working on a balloon frame 2 story built in 1930, not much building code back then. 2nd story floor joists are 2x6 on 24" centers pinned to the vertical studs (no ribbon board). He let us change the joist support from ribbon board to jack on the rear of the house, and balloon to platform framing on the front. We did this with a sketch on site, very helpful - no engineer required!
I've worked some places where the women squawked and got the stand up desks
one in particular they all stopped using them as whenever a dude came into the office they'd check out the booties
desks down and bums back into the chairs
mining industry males, even the educated ones, are not completely house-trained
a good chair and proper positioning of monitor and input devices for posture I'd rate higher
Had a guy on site that the union sent...everyone warned the Contractor...watch this guy he's trouble with women. Has threatened men before that he'll 'slit their throat' (myself included). He was talked to by the Contractor 'You're on notice, we have had warnings and you will not have a warning if you mess this up.'
Within 12hrs he was on a chopper off site because he cornered a cleaning lady for the camp and begged her to look at his weiner...'don't you love me baby? why you block my phone calls?'
that's ****** up, what a jerk
and I'd hold the union also partially responsible
they should know to get that guy off the roles
pay union rates, you should get mine qualified people
that's ****** up, what a jerk
and I'd hold the union also partially responsible
they should know to get that guy off the roles
pay union rates, you should get mine qualified people
I was apprenticing on a job at the Atrium on Bay (check out some of my ceilings while you're there). There was only one super on the whole job at the time, so you'd see him about once a week, whether you were lucky or unlucky. The company was short on workers, so they had a standing order in at the union hall for more. A couple of "journeymen" were given the task of laminating drywall onto the concrete block (I think they were from the B local). They got to a spot where a conduit ran up the wall. Instead of building out the wall around the conduit, they smashed it flat and then went over it. It took the electricians a few days to find the short. Cost the company big bucks in back charges. The two were laid off. A week later the union sent them back to the same job site.
I was apprenticing on a job at the Atrium on Bay (check out some of my ceilings while you're there). There was only one super on the whole job at the time, so you'd see him about once a week, whether you were lucky or unlucky. The company was short on workers, so they had a standing order in at the union hall for more. A couple of journeymen were given the task of laminating drywall onto the concrete block. They got to a spot where a conduit ran up the wall. Instead of building out the wall around the conduit, they smashed it flat and then went over it. It took the electricians a few days to find the short. Cost the company big bucks in back charges. The two were laid off. A week later the union sent them back to the same job site.
I've been working from some since March and will continue to do so until next March. I don't have a standing desk; I just take frequent breaks to go outside or clean my house.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.