Speedometer reads higher !!! any suggestions ?

[jeffjones]

I did not mean gearing. I meant SpeedoHealer and SpeedoDRD devices. My understanding is that the signal comes from a single source, a wheel speed indicator, which is then translated into a speedometer reading via simple math. Since that signal doesn't seem to be interrupted in any of these devices, then split off and calculated separately by the ECU, I fail to see how one can change just the speedometer reading without affecting the odometer value itself.

Are you 100% SURE they calibrate BOTH speedometer AND odometer to correct values? If so, can you provide evidence, for I have testimony to the contrary.

Not sure exactly what you mean by this?
On my bike if you change your gearing your odometer and speedometer will be effected.
From the speedohealer website in the FAQ section (#5) it says since there is only 1 speed signal it will calibrate them both: http://www.healtech-electronics.com/

 

[viper84737]

Not sure exactly what you mean by this?
On my bike if you change your gearing your odometer and speedometer will be effected.
From the speedohealer website in the FAQ section (#5) it says since there is only 1 speed signal it will calibrate them both: http://www.healtech-electronics.com/

Please go back and re-read my posts in this thread. I never mentioned gearing once.

According to this FAQ we have our answer for Speedohealer, if not both. It says it will calibrate them BOTH, which is unwanted. We only want the speedometer data calibrated, as the bike's computers are already calibrated properly for odometer information.

Q.E.D.

 

[jeffjones]

Please go back and re-read my posts in this thread. I never mentioned gearing once.

According to this FAQ we have our answer for Speedohealer, if not both. It says it will calibrate them BOTH, which is unwanted. We only want the speedometer data calibrated, as the bike's computers are already calibrated properly for odometer information.

Q.E.D.

Ok, I was getting confused and didn't realize you were talking about the factory error, Most people don't get a speedohealer to fix the factory error as every vehicle ever produced has one somewhere between +/-10%.
Majority of people that use these devices are the ones that change their gearing and their speedos are off 15-30%.

 

[absolute]

Are you 100% SURE they calibrate BOTH speedometer AND odometer to correct values? If so, can you provide evidence, for I have testimony to the contrary.

yea im sure it corrects both values. matched the before and after to my buddy's R6 which has a correct reading odo.
after a ride i was reading 9km higher than him (78/69) and we started the ride at the same place and ended the same place comparing odometers before and after the ride

after installing the speedodrd, also compared the odo before and after ride, and we were now logging excatly the same distance on the odo

plus to install the speedoDRD, i have to disconnect the speed sensor just infront of the front sprocket, and plug the speedoDRD inbetween that and the wiring that goes to the clusters

 

[TheDirty]

I am under the impression these devices will throw off the odometer while fixing the speedometer. Any insights?

That would depend on whether the factory speedo error is accounted for in the factor odometer calculation. I'm not sure if it is or isn't. It's most likely that the odometers are slightly off as well. I remember some highways where you could check your odometer readings and they had mile markers on the side of the road. I guess you could try the same thing with the GPS now.

 

[Brian P]

I am under the impression these devices will throw off the odometer while fixing the speedometer. Any insights?

That would depend on whether the factory speedo error is accounted for in the factor odometer calculation. I'm not sure if it is or isn't. It's most likely that the odometers are slightly off as well. I remember some highways where you could check your odometer readings and they had mile markers on the side of the road. I guess you could try the same thing with the GPS now.

The odometer and speedometer cannot be independently made "accurate" without affecting the other one.

On most production vehicles, with the factory setup, it will be found that the odometer is accurate within a small percentage (+/- 1% is not unusual and is mostly due to tire rolling diameter tolerance, tire wear, etc) and the speedometer will intentionally display a higher number than the actual speed. It isn't that the computer that displays the odometer and speedometer is wrong, the error is deliberately built into the instrument. The speed is calculated with the same precision as the odometer (using the same speed sensor signal) and then multiplied by 1.07 (or whatever) before being displayed. This happens internally to the little microcomputer that operates the display, so there isn't anything that can practically be done about it.

If you alter the speed sensor signal input to that microcomputer, you can artificially divide the speed sensor signal by (let's say) 1.07 to get the speedometer displaying the correct speed, but this will throw off your odometer and trip-meter by exactly the same factor.

If you are anal about calculating fuel consumption or oil change intervals then you will have to make that adjustment when doing that calculation to get your actual fuel consumption based on kilometers "on the road" as opposed to the displayed (and now slightly incorrect) number.

Personally, given this choice, I'd rather have the speedometer correct and the odometer wrong.

 

[Rotten_Ronnie]

Check to see if it is a true reading at 80kph. I heard it was a calibration benchmark.

 

[GVH]

http://www.12oclocklabs.com/ Used this on my DL6550 Cheap and works well.

 

[frasermanx]

Get a bike speedo. Best $10 you will spend

 

[chiefswallow]

Get a bike speedo. Best $10 you will spend

3 day temp ban for useless thread bump.