Help with install of fender eliminator!

KawasakiGal

KawasakiGal

Well-known member
Site Supporter
Forum Sponsor
Just purchased fender eliminator, looking to install this week or on weekend!

I would actually like to do it myself, I have been attempting much of my bike work on my own, but wouldnt mind a garage space to work in or a dremel tool (one thing I dont own), Im told there is a template and my current needs to be very precisely cut, this job at the dealer is a 3 hour charge, which seems silly....

Also I can bring beer for the extra hand!

Thanks

Jenn
 
3 hours is way too long. It fairly simple after the first time around. I cut mine too far, but it was alright. I'm probably too far for you to be using a garage space.
 
Where are you located, Kawigal? I'm up in Brampton, have a garage, a dremel and installed my FE kit on my bike myself. Nice to meet other female riders as well. Give me a shout! :)
 
I can help you install it if needed. I have all the tools needed. If you have the little plastic connectors (plug locks) used on most body pannels around the seat and rear of the bike you may want to get a few spare before you tackle the job. Sometimes they dont hold as good when pulled out a few times.
send me a PM if needed
 
Thanks for all the replies I'm at younge and eg don't care if i have to ride a bit... Sooner then later would be better..... After 5pm... LetMe know what days might work for everyone that way I can pick what might work best for meToo..Thanks again everyone!!!Jenn
 
You must log in or register to reply here.
Back
Top Bottom