Engine immobilizer won't disarm after battery replacement | GTAMotorcycle.com

Engine immobilizer won't disarm after battery replacement

S

spaz619

Active member
Bike: 2007 Kawasaki ZX6R
Alarm: hornet merlin 3000


I replaced my battery yesterday for the first time since buying the bike used. After hooking the battery up, the alarm is not working as it did. The alarm system does not "chirp" when arming/disarming the system (lights still flash though) AND the engine immobilizer won't disarm.


Hoping someone has a solution
 
spaz619 said:
Bike: 2007 Kawasaki ZX6R
Alarm: hornet merlin 3000


I replaced my battery yesterday for the first time since buying the bike used. After hooking the battery up, the alarm is not working as it did. The alarm system does not "chirp" when arming/disarming the system (lights still flash though) AND the engine immobilizer won't disarm.


Hoping someone has a solution
Click to expand...
Did you hook up all the wires? Did some dodgy wiring get nudged and now it is no longer making a proper connection?


"The system will not arm or disarm.
z Make sure the ignition is not turned on or that the yellow ignition wire does not have 12volts.
z Make sure the systems 5 amp main fuse has been installed or is not blown."
 
Re : AND the engine immobilizer won't disarm.

Probably due to a loose connection and/or the ECU logic getting out of sync with the use of the arm/disarm button vs having the key in the ignition.
Please check the wiring and fuses and scan the ECU for error codes.

My 2 c.
 
Cycle the key on and off a few times, just a thought
 
You must log in or register to reply here.

Back
Top Bottom