machine shop for custom engine work.

S

starboy869

Well-known member
Forum Sponsor
Could anyone recommend a custom machine shop for punching out some cylinders. Mainly doing a rebuild on an old honda two stroker going from a 57mm to a 63mm piston. Anywhere in canada or usa is fine. Looking for excellent workmanship.
 
I used Kustom Kraft Performance over 20yrs ago to put an iron liner into damaged RM250 cylinder. It was good. I just googled them, still in business. I would use again.
 
Gord Bush at Gord Bush Racing. Off of Kipling in TO. My jugs are being bored and ported by him. He's rebuilding my crank too.

He comes highly recommended by the RZ350 board.
 
He has over a 4 week backlog - that usually happens when you are good and in high demand.
 
Re: machine shop for custom engine work.

Originally Posted by rzresurection
Gord Bush at Gord Bush Racing. Off of Kipling in TO. My jugs are being bored and ported by him. He's rebuilding my crank too.

He comes highly recommended by the RZ350 board.
+1 ...Ive heard good things about em


Khan450 said:
+1 ...Ive heard good things about em
Click to expand...
Rebuilt my cranks and bored out my cylinders on an RG500. This is who you want.
 
Last edited:
Over the years i've heard excellent things about bush as well and he known to be backlogged. I just forgot about him until mentioned here. I'll be getting a hold of him.
 
You must log in or register to reply here.
Back
Top Bottom