scorpio i900 install problems..... need help

contact148

Well-known member
I bought a scorpio i900 alarm from a member here

I ordered the wire kit or my bike 2013 gsxr 600 wire kit suz12 I installed alarm turn signals DO NOT flash when I arm or disarm they DO work when I use the turn switch so wires are good......

alarm manually arms and disarms perimeter sensor works alarm will NOT auto arm or auto disarm

if it is armed I walk up with remote turn key and alarm goes off remote shows ignition key picture and I have to manually turn it off

I did NOT install ign kill

I did NOT cut any wires

I have hooked it up several times and no change I synched the remote several times

need help!
 
I am going to guess that you choose not to connect the pinkesh cable to the rear license plate light?
 
I used the plug and play harness no pinkish cable all plugs were connected except I did not plug in the ignition kill
 
The alarm uses the cable you are supposed to plug to the rear light as the power. The symptoms you are describing are the same as I got because I did not connect that cable, it seemed like the alarm had power but it didn't.

I would suggest ensuring that one cable that is supposed to be connected to the rear light (ignition power) is properly connected.

If all is properly connected then Email them, they respond pretty quick.

Edit: The pink cable I was referring is on the generic stock harness, it would not apply to you. It could be a bad harness.
Maybe try using the stock generic harness an see if that works, or if you have a multi-meter test all the cables on the harness you ordered for continuity.

Also make sure you connected the ground cable (black cable) to a proper ground. I am not sure if this applies with your harness. Hard for me to help because I used the Generic harness.

But it seems you do not have power going into it, the unit does not get fully powered by the cable going into the positive of the battery.



I used the plug and play harness no pinkish cable all plugs were connected except I did not plug in the ignition kill
 
Last edited:
well when I plug the harness into the alarm it does beep so im guessing its supplying power I checked every wire with my meter all checked out im stumped with this
 
well when I plug the harness into the alarm it does beep so im guessing its supplying power I checked every wire with my meter all checked out im stumped with this
Contact them, they have good support.

I was also stomped and it was something small. Once you get that alarm working it will give you no issues. It works great
 
Last edited:
Sounds like something is wrong in the wiring - a multimeter and test light should be able to troubleshoot it. Alarms are pretty stragiht forward.
 
Got a replacement remote and unit a fewweeks ago installed itwas fine for last 2 weeks bike was in my garage it armed and disarmed as it should
Today I went for a 1 hour ride got home bike armed when I left it disarmed when I approached pushed it into my garage and alarm went off and kept going off
Rfd symbol on remote wont show I cant turn it off manually took bike apart for the THIRD time everything is as it should be alarm doesn’t recognize remote Tried recoding it wont work I've had it with this alarm

As of now DO NOT BUY a scorpio alarm I hate it and its 100 % useless im sure they will want me to send it back AGAINat $40.00for shipping
 
Last edited:
Wow I have heard nothing but good things including Mt own experience. That sucks
 
Back
Top Bottom