noelocol
Well-known member
You dont see much of these Springer front end around much.
This is a mid 60's early 70's complete Springer front end.
Its all complete including the axle and an adjustable spine so as to fit different bikes. The rockers are nice and clean.
Its ready to go on to your chopper or bobber but you'll just need the neck bearing depending on your bike.
It was most recently on a 69 Triumph T120
Slight surface rust under the bottom tripple but would clean up real nice with some WD40 and steel wool.
Length is approx 28 inches from axle to bottom tripple so that would make it approximately 6" over
$600 firm. I would however consider some interesting trades for bobber/chopper parts for a triumph.
More pics are avaliable.
perfect for your xs650, Cb550, Triumph, harley bobber or chopper.
Located downtown Toronto - 416 888 3030
This is a mid 60's early 70's complete Springer front end.
Its all complete including the axle and an adjustable spine so as to fit different bikes. The rockers are nice and clean.
Its ready to go on to your chopper or bobber but you'll just need the neck bearing depending on your bike.
It was most recently on a 69 Triumph T120
Slight surface rust under the bottom tripple but would clean up real nice with some WD40 and steel wool.
Length is approx 28 inches from axle to bottom tripple so that would make it approximately 6" over
$600 firm. I would however consider some interesting trades for bobber/chopper parts for a triumph.
More pics are avaliable.
perfect for your xs650, Cb550, Triumph, harley bobber or chopper.
Located downtown Toronto - 416 888 3030
