taxnatural
Well-known member
I have 1 and I'm not sure how to install or if the wiring harness is even still on the bike.........if its not where do I find it?
|
|
|
Anyone install a speedohealer v4?
- Thread starter taxnatural
- Start date
Unplug the connector for your VSS (vehicle speed sensor), plug the mating plugs of the Speedohealer into the plugs on the harness side and VSS side (it will only go together one way), route the wires to wherever you want to put it.
The VSS is on your countershaft sprocket cover. Follow the wire to the plug where it connects to the vehicle's wiring harness. That's the spot where the Speedohealer plugs in. You might have to take the lower fairing off to get access to that plug.
The VSS is on your countershaft sprocket cover. Follow the wire to the plug where it connects to the vehicle's wiring harness. That's the spot where the Speedohealer plugs in. You might have to take the lower fairing off to get access to that plug.
I love my SV. No need for a Speedohealer since it takes the speed reading from the front wheel rather than the rear.
I tested my speedo's reading against 2 different GPS units @ 110km/h on the highway and I was about 3 to 5 km/h off. Nothing to complain about!
I tested my speedo's reading against 2 different GPS units @ 110km/h on the highway and I was about 3 to 5 km/h off. Nothing to complain about!
taxnatural
Well-known member
anyone else?
Dohhh
Banned
ya but your bike is slow
If this is for his 929, its not on the sprocket cover FYI
OP do you have the bike specific wiring harness, or the hard wire style where you need to tap into the speedo sensor yourself?
taxnatural
Well-known member
Its for my gsxr 600 07
|
|
|
|
|