2011 ZX-6R & HID Installation

[gobu]

Hey Guys!

I need to confirm the following:

(1) H9 bulb for low beam (right-hand-side of the vehicle) & H11 bulb for high beam (left-hand-side of the vehicle), true?

(2) 35W vs. 55W system - 55W can be installed with replacing the stock fuse with a higher AMP rating, true?

(3) Instead of getting 1 bulb for H9 & 1 bulb for H11, I can either both of each types (e.g. 2 of H9's or 2 of H11's), and IT WILL fit through the bulb housing holder? or do I need to do a little bit of trimming here and there to make it work?

(4) Planning to utilize relay's to turn on both headlights (left and right) at the same time, and manually adjust the angle of light using the screw-assembly for the high-beam to match the low-beam, so, to avoid blinding others on the road ...

Basically, I want a 55w system with 8000K bulbs, having both headlights ON/OFF as I desire.

 

[jeffjones]

1. I'm not sure?
2. There is no need to get 55W as 35W are bright enough and the extra light is just going to get scattered into other drivers eyes.
3. Don't know?
4. I would assume if it is like the F4i there are 2 different reflectors in your headlight so just angleing it down will not have the same effect as 2 Lo-beams as well you will not have Hi-beams for if your going quickly down those "closed courses" in the backroads with no street lights.

Hopefully you are good at wiring if you plan on running 55W HID's through the same relay to turn them both on and off.
Also 55W 8000k's are the same spectrum colour as the 6000k 35W, the extra wattage takes some of the blue away.
Be sure to check the max amps your stock wiring can take before you run them through the same relay because if you up your fuse to handle them you run the risk of frying your wiring.