Recent content by Renboy

That ain't going anywhere.

Both the McDonalds case and this Starbucks case happened at a drive-thru. Just ban all drive-thrus and the problem is solved. It'll also help lower emissions, and obesity as people will actually have to get out of their cars and waddle over to the poison dispensery.

Replaced the torque converter in my sister's 2017 Escape. What a hateful fcuking car it is to work on. Every damn bolt is a bi+ch bolt. Unquestionably the worst designed car as far as repairs are concerned that I've ever personally had to deal with. You would think that a car company that...

Rotella T6 for years in all street and race bikes. Stocked up when Danté and I were in the States about a month ago. Will probably buy a couple more jugs at Canadian Tire with that promo. Thanks.

Someone's trying to make up for some short comings.:whistle:

Becoming Led Zeppelin. Brilliant.

There was a video? @mimico_polak although I agree that most people are useless they should strive to be less so. To replace a single bolt with another bolt shouldn't even be up for discussion, though sadly here we are. I also agree that people shouldn't be responsible for fixing a poor...

Replace that banjo with a banjo/bleeder combo. See if that helps fix the problem. For under $20 it's cheaper than a trip to the dealer.

Now I support camera vandalization even more than I though possible.

Why don't they put these "community safety zones" on dead end or side streets instead of on a provincial fuickng highway? Same when they build new subdivisions and put a brand new school on what will be a busy road, then put a stupid slow speed limit there. Planners are asshats.

So my question is why is the fine from speed cameras way higher that if you got it from a cop? I got hit doing 11 over in a 50 zone and rather than the $48.50 that the fine is when a cop hits you with it, I got a bill for $88. Now that I know where the camera is, how much copper and valuable...

Is there no track between Ontario and Rad Torque that they could add another round to replace RMM? Hit it up on the drive back to Ontario.

This is correct, I forgot about Acme. His name is Craig Atkinson.

Andrew Westbrook is in Guelph, so my guess is he's the closest you'll find to Hamilton for suspension setup. Good guy as well.

Stator rotor stays on the ninja crank, no need to remove it. Otherwise Brian got it pretty much spot on. Starter motor needs to come off as there are 6 bolts that go down through the top case and into the bottom case. The starter sits directly above 2 of the 6 bolts.